Task--Maximum Number of Points for Completing Correctly

1. Adherence to all design rules --5

2. Allowed for etch back on inner planes --5

3. Board fiducials placed --5

4. Fingers extended beyond edge of board to facilitate gold plating --5

5. Tooling holes placed --5

6. Usable drill data was provided --5

7. GND & Analog_GND plane was split correctly --5

8. Origin of Gerber & Drill Data was consistent with Fabrication Origin --5

9. Bypass & Filter capacitors were adequately placed --5

10. Fabrication Drawing was provided --5

11. Inputs away from outputs in analog circuitry --2

12. Added 12V Plane or Split VCC Plane --2

13. Like components in same direction --2

14. Pin & Gate Swap to optimize trace length --2

15. Added extra vias on Power connections from edge connector to plane --2

16. Fiducials were placed at fine pitch part --2

17. Test points were provided --1

18. Assembly Drawing was provided --1

19. Bonus Fabrication Drawing items provided: -
Tooling hole to be board origin (X0, Y0) --1
Hole Tolerance --1
Material & Thickness --1
Copper Spec --1
Gold Contact Spec --1
Finish Spec --1